Check this out. Hope this helps! Fishing Ideas. Fishing Videos. Giveaways Giveaways Giveaway Winners. So, do you need to soak the fishing line before spooling? Yes, you need to soak the fishing line before spooling as soaking your fishing line in a bucket of warm water will help when you come to wind the line on your spool. This will reduce tangles and ensure better casting performance. The most recommended method is to soak the majority of the spool in a bucket of warm water.
This will allow the water to saturate the line, and it will bend effectively when you are wrapping it without the need for additional pressure. Mostly you only need a few hours of soaking time, but some experts recommend leaving the line to soak overnight for the best results. Line Twist is one of the most common problems that any angler can face. It leads to tangles and eventually causes severe damage to your line. Line twist basically happens when your fishing line spins around in a tight spiral.
When the line is rigid it can be unnoticeable to the eye, but when you let the line loose, it will be much more apparent. All types of fishing lines can twist; however, some are easier to manage than others:. You can check the best monofilament lines here and the best fluorocarbon lines here. This method works particularly well with fluorocarbon main lines and heavy monos that retain a lot of spool memory from the storing bulk spool.
This will make the line suppler and remove some of the storage memory. It will also mean you can add some tension to the line with your finger and thumb when spooling-up without burning your skin via the friction heat. Place the spool on the ground so that the end of the spool that allows the line to leave in an anti-clockwise direction is facing you. This means that as you spool-up the coils in the line will load onto your reel in the same direction they are leaving the bulk spool.
Tie the line to the spool and begin to load the line, but as you do so guide the line between your forefinger and thumb under tension. This will help remove line memory and give a better line-lay. This technique works best with low diameter lines that are already quite supple with little existing twist or memory, as well as loading braid as the main line. If so, darn it, I didn't put it into soak last night and need to load spools tonight.
What to do? To be honest I've soaked for 24 hours and I've also just loaded through a damp cloth and so far I've had no problems. Think with sensor I just loaded with a damp cloth but it was about 6 years ago I used sensor. Think most do soak though. God knows! I think Dan's already loaded the reels nm. Oh ok it was the "need to spool em tonight" that threw me. Never been sold on the soak in warm water method, there is a school of thought that this may cause curly line.
You absolutely, have to, most importantly, without doubt soak line for 2 millenia before spooling or you won't catch anything but Bream. Explains the curly wurlys on me right hand rod. Hi guys. Sorry about delay in replying, in a room where couldn't be on my phone. So, basically I'm interested to learn everyone has there own little take on it. I haven't loaded the line yet, but I've found a really good recipe online. You soak in warm water for 12 hours, then you put it all in a slow cooker for 6 hours.
Then you add Gravy Granules, chopped tomato, star Anis, cayenne pepper and finally salt and pepper. Bring to the boil for 10 minutes, then allow to air dry for seconds.
0コメント